Brenner race car lift and intructions for assembly

Nicholas and Mark Belling of Canada with the Brenner Lift

it comes in handy for all sorts of lifting as well as race cars, such as a root shown above.

Custom Sizing

We can make a lift to your height and width specifications at nominal cost.

One of our customers has used the lift to stack two cars in a trailer for transportation. The lift was made narrower and lower to fit the trailer. This idea saved the cost of buying a stacker or bigger trailer !

Other customers have had shorter lifts made to fit garages with lower ceilings.

This amazing Race Car Lift can lift 1800lbs and over. It is made out of super strong steel The lift weighs a lightweight 160 pounds when put together and rolls easily on castors. Each castor is rated for 1200 lbs. It is easy to transport because it breaks down into five separate pieces the heaviest piece is the top with the winch at about 70 pounds. Unlike the A frame it has no bolts so is so easy to put up or take down, and takes about three minutes to assemble. It does not get in the way when working on a car because the side pieces are straight.

It can be powered by a regular car battery, the wires from the lift have a plug on the end of them . A battery can easily be hooked up with a connecting plug and wires. On the right are wires leading to the control button. The wires are long enough for the person operating the lift to have room to move around, see picture below. When not in use they hook conveniently to the top of the lift and also detach for storage. The top cross piece of the lift also is useful for displaying your racing logo.

The dimensions are: height 89 " outside width 86 1/2" Total weight 160 pounds

Price of Lift $1629.00 with everything. Plus tax if you live in CA. and shipping.

Shipping cost varies depending on location, we ship UPS

email dougas@brennerfab.com phone 707 964 6226

step 1and 2

step3

Instructions for Lift and Stand

Lift Assembly

1. Start out by taking one bottom and locking the casters.

2. Insert one of the uprights into the pocket of the above part.

3. Insert the assembled bottom and upright into a pocket on the top frame.

At this point the lift will stay upright on it’s own.

4. Lift the other end of the top frame , making sure that the two pockets and upright of the existing assembly are fully engaged and insert the second upright into the remaining pocket.

5. Insert bottom of the upright into pocket of remaining bottom.

Basically, you just start at the bottom of one side and work your way around to the bottom of the other side. It is important not the assemble the second upright and bottom before you insert it into the top frame because it is difficult to lift it high enough. After a few times assembly becomes very quick. Disassemble is exactly the reverse.

Brenner Stand Instructions

With mid engined cars, be sure to locate the rear part of the stand as close forward of the flywheel of your motor as you can. Adjust the front as needed.

We accept credit cards see home page